« Previous - Version 7/38 (diff) - Next » - Current version
Rich LeGrand, 02/19/2014 10:43 pm


Assembling pan/tilt Mechanism

The pan/tilt mechanism when combined with Pixy, makes a fun demo — a good “hello world” for Pixy (no Arduino required). The Pixy pan/tilt mechanism comes in a kit and requires some assembly.

You will need (in addition to a Pixy and a pan/tilt kit):

A small phillips screwdriver

pliers

small wire cutters

1. Find one of the long servo horns inside one of the servo baggies, and clip it on the 3rd hole from the end.

2. Put the servo horn on the servo and check both ends of travel. You can do this by moving the horn all the way to the right:

and then all the way to the left:

and adjusting the mounting angle of the horn such that the center of travel has the servo horn pointing downwards.

3. Find one of the servo horn fasteners in the one of the servo baggies:

and screw the servo horn tightly. (Here the servo is shown with the servo horn pointing downwards, which should be roughly the center of travel.)

4. Remove the paper backing on the pan/tilt body (the smaller of the two acrylic parts).

5. Fit the servo mounting tab into the slot on the pan/tilt body.

6. Flip the body over and thread a cable tie through the cable tie slots in the body.

7. Thread another cable tie through the other cable tie slots in the body.

8. Tighten both cable ties by using pliers. It requires quite a bit of force to fully tighten!

9. Take the 2nd servo and place in the other hole in the body as shown in the picture.

10. Take two longer 4-40 fasteners:

and use the secure the 2nd servo.

11. Take all five right-angle brackets out and examine them. Notice that three of them have two threaded holes and and two of them have one threaded hole. We'll call these two-threaded and one-threaded brackets, respectively.

Grab a two-threaded bracket. If you look really closely, you'll notice that one of its legs is ever-so-slightly longer than the other. Say what? It's true--- I don't know why. But you can best see this by looking at the holes in the bracket. One of the holes in centered in its leg and the other hole is not centered, because its leg is slightly longer. Weird.

Take two longer 4-40 fasteners and attach two two-threaded brackets to the body as shown in the pictures below. Attach them such that the short legs are touching the body and the long legs are pointing up.


Nice. Now put this assembly aside for now.

12. Take your Pixy and attach two one-threaded brackets to it as shown in the picture below. Use two shorter 4-40 fasteners to do this.

13. Take two nylon bushings and press them into the non-threaded holes in these brackets.

14. Slide the Pixy into the body assembly as shown. Use two longer 4-40 fasteners to hold the two assemblies together. Don't tighten these fasteners too tight or it will cause binding. (This is the tilt axis and you want it to move freely.) Also make sure that the brackets are mounted squarely--- this can cause binding also.


15.